This shows you the differences between two versions of the page.
— |
gnucap:manual:commands:pause [2015/12/11 15:39] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== "pause" command ====== | ||
+ | |||
+ | ===== Purpose ===== | ||
+ | |||
+ | Suspend batch mode. Wait for the user to hit a key. | ||
+ | |||
+ | ===== Syntax ===== | ||
+ | |||
+ | pause comment | ||
+ | |||
+ | ===== Status ===== | ||
+ | |||
+ | This command does not work on all systems, due to buffering of console i/o. | ||
+ | |||
+ | ===== Comments ===== | ||
+ | |||
+ | Prints Continue? and waits for a key hit. Type `n', `N', escape or control-c to terminate the batch mode. Type anything else to continue. | ||
+ | |||
+ | Any comment is ignored. | ||
+ | |||
+ | ===== Examples ===== | ||
+ | |||
+ | pause Try more gain | ||
+ | pause | ||
+ | These both work the same. Ask to continue, wait for a key hit, then go on. | ||