This shows you the differences between two versions of the page.
— |
gnucap:manual:commands:outfile [2015/12/11 15:39] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== ">" command ====== | ||
+ | |||
+ | ===== Purpose ===== | ||
+ | |||
+ | Saves a copy of all program output (except help) in a file. | ||
+ | |||
+ | ===== Syntax ===== | ||
+ | |||
+ | > file | ||
+ | >> file | ||
+ | > | ||
+ | |||
+ | ===== Comments ===== | ||
+ | |||
+ | ''>'' creates a new file for this output. If the file already exists, the old one is lost, and replaced by the new one. | ||
+ | |||
+ | ''>''''>'' appends to an existing file, if it exists, otherwise it creates one. | ||
+ | |||
+ | A bare ''>'' closes the file. | ||
+ | |||
+ | ===== Examples ===== | ||
+ | |||
+ | > run1 | ||
+ | Save everything in a file run1 in the current directory. If run1 already exists, the old one is gone. | ||
+ | >> allof | ||
+ | Save everything in a file allof. If allof already exists, it is kept, and the new data is added to the end. | ||
+ | > | ||
+ | Close the file. Stop saving. | ||