This shows you the differences between two versions of the page.
— |
gnucap:manual:commands:build [2015/12/11 15:39] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== "build" command ====== | ||
+ | |||
+ | ===== Purpose ===== | ||
+ | |||
+ | Builds a new circuit, with Spice syntax. | ||
+ | |||
+ | ===== Syntax ===== | ||
+ | |||
+ | build | ||
+ | |||
+ | ===== Comments ===== | ||
+ | |||
+ | "Build" lets you enter the circuit from the keyboard. The prompt changes to > to show that the program is in the build mode. | ||
+ | |||
+ | At this point, type in the circuit components in Spice netlist format. | ||
+ | |||
+ | Component labels must be unique. If not, the old one is modified according to the new data, keeping old values where no new ones were specified. | ||
+ | |||
+ | Components are added to the end of the list. | ||
+ | |||
+ | Components being changed or replaced do not change their location in the list. | ||
+ | |||
+ | If it is necessary to start over, "delete all" or "clear" will erase the entire circuit in memory. | ||
+ | |||
+ | To exit this mode, enter a blank line. | ||
+ | |||
+ | This command is deprecated, and may be removed in a future release. You can use the command "spice" instead. | ||