FOURIER command

2.18 `FOURIER` command

2.18.1 Syntax

fourier start stop stepsize {options ...}

2.18.2 Purpose

Performs a nonlinear time domain (transient) analysis, but displays the results in the frequency domain.

Start, stop, and stepsize are frequencies.

2.18.3 Comments

This command is slightly different and more flexible than the SPICE counterpart. SPICE always gives you the fundamental and 9 harmonics. Gnucap will do the same if you only specify one frequency. SPICE has the probes on the same line. Gnucap requires you to specify the probes with the print command.

SPICE uses the last piece of a transient that was already done. Gnucap does its own transient analysis, continuing from where the most recent one left off, and choosing the step size to match the Fourier Transform to be done. Because of this the Gnucap Fourier analysis is much more accurate than SPICE.

The nodes to look at must have been previously selected by the print or plot command.

Three parameters are normally needed for a Fourier analysis: start frequency, stop frequency and step size, in this order.

If the start frequency is omitted it is assumed to be 0. The two remaining parameters are stop and step, such that stop > step.

If only one frequency is specified, it is assumed to be step size, which is equivalent to the fundamental frequency. The start frequency is zero and the stop frequency is set according the harmonics option (from the options command. The default is 9 harmonics.

If two frequencies are specified, they are stop and step. The order doesn't matter since stop is always larger than step.

Actually, this command does a nonlinear time domain analysis, then performs a Fourier transform on the data to get the frequency data. The transient analysis parameters (start, stop, step) are determined by the program as necessary to produce the desired spectral results. The internal time steps are selected to match the Fourier points, so there is no interpolation done.

The underlying transient analysis begins where the previous one left off. If you specify the "cold" option, it begins at time = 0. Often repeating a run will improve the accuracy by giving more time for initial transients to settle out.

See also: Transient command.

2.18.4 Options

> file

Send results of analysis to file.

>> file

Append results to file.

cold

Zero initial conditions. Cold start from power-up.

dtemp degrees

Temperature offset, degrees C. Add this number to the temperature from the options command.

dtmin time

The minimum internal time step, as a time. (Default = option dtmin Time cannot be resolved closer than this.

dtratio number

The minimum internal time step, as a ratio. (Default = option dtratio This is the maximum number of internal time steps for every requested step.

quiet

Suppress console output.

skip count

Force at least count internal transient time steps for each one used.

temperature degrees

Temperature, degrees C.

trace n

Show extended information during solution. Must be followed by one of the following:

off: No extended trace information (default, override .opt)
warnings: Show extended warnings
alltime: Show all accepted internal time steps.
rejected: Show all internal time steps including rejected steps.
iterations: Show every iteration.
verbose: Show extended diagnostics.

2.18.5 Examples